DIY: Wine Rack

Wine Rack DIY from The Merry Thought

(themerrythought)

Step One:
Gather your materials-
-1/2″ x 12″ x 24″ Birch Plywood
-Scroll Saw
-Three 5/8″ Dowels
-Drill
-5/8″ Forstner Drill Bit
-Wood Glue
-Four 1″ x 20″ pieces of Leather
-Sewing Machine

Step Two:
"Draw line across the board at 11 5/8in from one end (this gives an extra 3/8in to the back side of the stand) Use the saw to cut along this line."

Step Three:
"On the top half, (the one with the extra 3/8in) measure 1.5in down from the top and make a mark at the center of the board and then a mark at 1in in from each side. Also mark 6 1/4in down from the top at the center and 1in in from each side. (These are for the dowels.)"

Step Four:
"Drill a hole most of the way through the board at each mark. Cut six 12in pieces of dowel."

Step Five:
"Screw the base piece of wood to the back of the stand. Glue dowels in place."

 

Step Six:
"Fold each piece of leather in half. Stitch across, giving enough room for dowel to fit through. About 1in." 

Step Seven:
"Now fold about an inch on each end and sew along the edge. 
Slide the leather on the dowels once they are completely dry and fill it up with your favorite wine!"

DIY: Sparkly Garter

Check out this amazing tutorial from All The Good Girls Go To Heaven Blog!

(allthegoodgirlsgotoheavenblog)

Step One:
Gather materials-
-Stretchy lace ribbon
-Rhinestone appliqué - get one here or here
-Needle and thread
-Hot fix rhinestones & rhinestone setter or iron (optional)

Step Two:
Cut lace to the correct length. 

Step Three:
Sew the 
appliqué to the center of the lace.

Step Four:
Arrange the rhinestones and iron on.

Step Five:
Turn inside out and sew lace closed.