DIY: Old Fashioned Glasses

(studiodiy/palmspringsstyle)

Step One:
Gather materials-
-Glasses
-Printable Starburst Motif (printable pattern template here, or design a stencil yourself), Printed on Cardstock
-X-Acto blade
-Cutting mat
-Liquid gold leaf
-Blue painter's tape
-Paintbrush

Step Two:
"First, cut out a rectangle shape around the starburst pattern. Then use your knife to carefully cut out the starburst shape from the rectangle, leaving you with a stencil. Rip off a piece of painter’s tape and tape it to your cutting mat. Place your stencil over top and carefully cut out the starburst shape from your tape."

Step Three:
"Peel your stencil off your mat and adhere it to your glass where desired, and then repeat the above steps until you have as many starbursts as desired on your glass. It is so so so important to run your fingernail over all the little cutouts of the starburst once it’s taped on the glass to ensure it is sealed on there well! This will prevent the gold leaf from leaking through the stencil."

Step Four:
"Open your liquid gold leaf and while working in a well-ventilated area, stir it well with your paint brush. Paint a thick but even coat over the starburst shape. If you find you need more than one coat, go ahead and add a second coat."

Step Five:
"Let dry thoroughly, then remove your stencils and you are done! If you do find that any starbursts didn’t turn out perfectly, you can use a toothpick or a cotton swab dipped in nail polish remover to remove any unwanted gold leaf."

 

Now fill your glasses with your most favorite cocktail and you are ready to party, mid-century style!

"

DIY: Pom Pom Blanket

(sugar&cloth)

Step One:
Gather materials-
-Throw blanket (from thrift shop, Target or just something lying around)
-Scissors
-Ruler
-Hot glue/Fabric glue
-Pom Pom Trim

Step Two:
Measure out length of blanket in order to cut the right amount of Pom Pom time. Snip snip!

Step Three:
Glue the trim onto the edge of the blanket a few inches at a time. Be careful not to get your fingers with the hot glue.

Step Four:
Let dry!